Gai-tronics MRTI 2000 (No. PL1877A) Microprocessor Radio Telep Uživatelský manuál Strana 109
- Strana / 172
- Tabulka s obsahem
- KNIHY
Hodnocené. / 5. Na základě hodnocení zákazníků
PL1877A Microprocessor Radio Telephone Interconnect Parameter Modification
103 12/10
Installation
To enable the station/repeater enable feature, program parameter 56 to 1.
N
OTE: The station/repeater enable feature is not available when the PL1877A is programmed for RX
VOX carrier detect (parameter 3 = 0; parameter 5 =1). This is because the monitor output is used for
channel scanning in that configuration.
The station/repeater enable prefix consists of 1–6 DTMF digits. Each digit has a valid range of 0-D.
Unused digits must be filled with FF (hexadecimal FF). To completely disable the prefix (thus requiring
only **# as the enable command), store FF in all digits.
Parameter Function
56 Disable station/repeater enable feature = 0
Enable station/repeater enable feature = 1
Default = 0
428-433 Station/repeater enable prefix.
Miscellaneous Features
Parameter Function
26 Disable multiple ringing to mobiles = 0
Enable multiple ringing to mobiles = 1
Default = 0
33 Disable “over” beep to phone user = 0
Enable “over” beep to phone user = 1
Default = 1
The over beep is returned to the phone user when the PL1877A detects loss of mobile
carrier. It indicates that it is the phone user’s turn to talk.
54
Don’t allow mobile user to access busy phone line with *** command = 0
Allow mobile user to access busy phone line with *** command = 1
Default = 0
If the mobile has attempted to access the PL1877A for an outbound call and the
PL1877A detects that the phone line is already in use by an attendant (line-sharing
telephone user), busy tones are transmitted to the mobile. The PL1877A continues to
return busy tones for 30 seconds, or until the attendant hangs up. If the attendant hangs
up, the PL1877A accesses the phone line for the requested outbound call. In this
situation the mobile can force the PL1877A to access the busy line by sending ***.
69 Ring signal generated to mobile is low frequency = 0 (low frequency is a 430/390 Hz
combination)
Ring signal generated to mobile is high frequency = 1 (high frequency is an 840/800 Hz
combination)
Default = 0
- Radio Telephone Interconnect 1
- Table of Contents 3
- Foreword 7
- Scope of Manual 8
- Nomenclature 8
- Ordering Replacement Parts 8
- Service and Repair 8
- Model Chart 10
- Kit Description 11
- Specifications 12
- Description 13
- WARNING 16
- Ground Cable 17
- Power Supply 17
- ON/OFF button. To 18
- Internal Diagnostics 19
- ON/OFF buttons 21
- Level Setting 23
- PWR for this test) goes on 24
- UP and PATCH ON/OFF buttons 24
- BUSY LED. Adjust control 24
- PC Programming 25
- IAPS Programming 26
- Input/Output 27
- Serial Port Setup 28
- Call Waiting 29
- Input/Output – Read Local 30
- Talk Battery Voltage 33
- Basic Operation 34
- Access/Release Settings 38
- Signaling 45
- Station Identifier 49
- Paging – Telephone Line 50
- Paging – Attendant Paging 51
- Paging – Mobile Paging 51
- Paging – General Paging 51
- Service Adjust 57
- Wildcard Access/Release 60
- Multi-Digit Access/Release 66
- Security Code Table 67
- No. Restriction 67
- Multi-Digit Release 68
- Operator Instructions 69
- Network Signaling 70
- Half Duplex Mode 70
- Standard Commands 71
- Auto-dial 71
- Selective Signaling Option 71
- 2nd Line Option 71
- Landline Originated Calls 72
- Bypassing Restriction Table 74
- First Bypass Parameter 75
- Parameter 76
- Third Bypass 76
- Second Bypass 76
- Terminal Programming Feature 83
- ENTER. The next 84
- DTMF Programming Feature 85
- Installation Parameters 89
- Enhanced VOX Simplex Mode 90
- Carrier Detect Methods 91
- General Purpose Inputs 92
- Miscellaneous 93
- Telephone Interface 94
- Dialing Characteristics 95
- Mobile Access Methods 97
- Manual Release Methods 98
- Automatic Release Methods 99
- General Call Characteristics 100
- Selectable Features 101
- Toll Restrictions 103
- Parameter Function 103
- Autodial 104
- Entry of Auto-dial Numbers 104
- Direct Channel Access 105
- Direct Access Timer 106
- Emergency Call Direct Access 108
- Installation 109
- Miscellaneous Features 109
- OTE: This 121
- Features 123
- Selective Signaling 124
- Attendant 125
- Group Calls 125
- 2-Tone Group Calls 126
- Dual Addressing 126
- Multi-Mode 130
- Motorola 5/6 Tone 134
- 5/6-Tone Single Mode Paging 134
- Types of Paging 135
- 2-Tone Paging 135
- Group Call 136
- TRANSMIT button, the console 136
- 12/10 132 138
- Plectron Paging 139
- 5/6 Tone 140
- DPL Code # = DPL Code 142
- PL1877A – Radio Installation 143
- Parameter Setting 144
- 139 12/10 145
- P1 Cable Color To Function 146
- MAXAR and MOXY Bases 148
- MAXAR 80 Bases 151
- MICOR RCB Repeater 155
- From To Function 155
- Cable Color To Function 155
- FLEXAR Repeater 157
- Color Function Plug Pin No 157
- Radio Cable Interfacing 159
- Color Function Terminal 159
- Theory of Operation 163
- Digital Signal Processing 164
- TX Audio 164
- Radio Interface 165
- Line Interface 166
- Optional Line 2 Interface 166
- Main Circuit Board 167
- Definitions and Acronyms 171
Související produkty a manuály pro Komunikace Gai-tronics MRTI 2000 (No. PL1877A) Microprocessor Radio Telep
Komunikace Gai-tronics XB001 Weatherproof Long-Life Battery Enclosure Uživatelský manuál
(5 stránky)
(5 stránky)
Komunikace Gai-tronics ITR1000-001 Model ITR1000-001 Basic Tone Remote De Uživatelský manuál
(40 stránky)
(40 stránky)
Komunikace Gai-tronics 13363 Addressable Amplified Speakers Installation Uživatelský manuál
(57 stránky)
(57 stránky)
Komunikace Gai-tronics MI05-101 Merge / Isolate Cabinet with External Opt Uživatelský manuál
(24 stránky)
(24 stránky)
Komunikace Gai-tronics MS05-101 Desktop Master Station consisting of Subs Uživatelský manuál
(11 stránky)
(11 stránky)
Komunikace Gai-tronics 12505-004 Repl. Door Kit for Weatherproof Enclosur Uživatelský manuál
(3 stránky)
(3 stránky)
Trane TRG-TRC003-EN manuals
Owner’s manuals and user’s guides for Unknown Trane TRG-TRC003-EN.
We providing 1 pdf manuals Trane TRG-TRC003-EN for download free by document types: User Manual
Komentáře k této Příručce